How to measure the power and temp of Hailo-8 M.2 async

[rybalkin]

@Nadav

import time
from hailo_platform import Device

def _run_periodic(delay=1):
    device_infos = Device.scan()
    targets = [Device(di) for di in device_infos]
    for i, target in enumerate(targets):
        target.control.stop_power_measurement()
        target.control.set_power_measurement()
        target.control.start_power_measurement()
    try:
        while True:
            for i, target in enumerate(targets):
                time.sleep(delay)
                power = target.control.get_power_measurement().average_value
                temp = target.control.get_chip_temperature().ts0_temperature
                print('[{}] {:.3f}W {:.3f}C'.format(device_infos[i], power, temp), end='\r')
    except KeyboardInterrupt:
        print('-I- Received keyboard intterupt, exiting')

    for i, target in enumerate(targets):
        target.control.stop_power_measurement()

if __name__ == "__main__":
    _run_periodic()

H i to All,

I support the question about the current monitoring being disabls on Hailo8l on RP5. I also have “Current Monitoring: Disabled”

I see the following output when attempt measuring power:

[HailoRT] [error] Firmware control has failed. Major status: 0x400300b4, Minor status: 0x400300b4
[HailoRT] [error] Firmware major status: CONTROL_PROTOCOL_STATUS_UNSUPPORTED_DEVICE
[HailoRT] [error] Firmware minor status: CONTROL_PROTOCOL_STATUS_UNSUPPORTED_DEVICE
[HailoRT] [error] Opcode HAILO_CONTROL_OPCODE_SET_POWER_MEASUEMENT is not supported on the current board.

Thank you and best regards!